Prium® Lehr – Integrated Annealing lehr
Complete annealing lehr solutions
With more than 25% of the worldwide flat glass lines installed, Fives is one of the top annealing lehr engineering provider of complete solutions with E&P or EPC.
We design and procure your annealing lehr according to your line process specification, product application, site situation, selecting the most appropriate solution to optimize your Capex and Return On Investment time.
We will assist you during commissioning, start up and can do production service on your demand.
Standard Float Glass Annealing Lehr: Prium® Lehr
Annealing Lehr for building, automotive and solar glass are typically producing soda lime glass ribbons with thicknesses ranging from 1.6 to 25mm and maximum pull up to 1200 tpd. Prium® Lehr is an integrated solution focusing on factors bellow to achieve a first class annealing lehr:
- Precise theoretical thermal balance calculation
- Patterned Hot Air Process
- Continuous Annealing Process
- Fuzzy logic temperature control
- Proportional control
- Experienced and Specialized service team
Thanks to more than 100 lines experience in annealing lehr design and smooth running, Prium® Lehr is the sole solution which will guarantee you an optimized investment and a trouble free annealing lehr operation.
Ultra-thin float glass world sets a new paradigm for glass makers: Prium® Lehr UTG
With ribbon thicknesses down to 0.35mm, ribbon width close to 5.4 m and difficult annealing due to specific glass composition (high Alumina, high Alkali), ultra-thin annealing lehr configuration becomes a real challenge.
In this specific world all details matter, every technical choice and trade-off can impact the final quality of glass sheets. Specific attention is paid on annealing curve on ribbon edge and centre both maintain to the design by optimized configuration and multi-section drive.
⇒ For recruitment-related matters (application, etc.), please do not use this form. Make your requests on this page.
In order to address your request, we need to collect the information listed in the form below
Information on data processing
As a data processor, FIVES implements personal data processing when managing your contact request. The data collected are required for this processing and are retained, unless you object, for a period of 6 months from the last contact between you and FIVES. If the information is incomplete, FIVES will not be able to respond to your contact.
The data collected are exclusively for the use of FIVES departments.
Pursuant to current legislation, you have the right to request access to data concerning you, their correction, deletion and portability, as well as a right of limitation over processing of your data.
These rights can be exercised by email to DPO@fivesgroup.com or by post to the Data Protection Officer at the following address: FIVES, 3 Rue Drouot, 75009 Paris, accompanied by a copy of an identity document.
In case of a dispute involving processing of your personal data, you have the right to make a complaint to the French Data Protection Agency (CNIL).
To find out more about our personal data protection policy click here